Control4 Drivers

Enables you to manage the state of Control4 Contact Sensors via programming.  This allows you to set and use Contact Sensors from many different sources which cannot be directly connected.

This driver is a simple convertor that allows you to use a Contact Sensor Input (like from a Controller, Z2IO, Z2C, etc….) within Composer and get a Keypad Connection output.

Features

• Quickly bind the contact connection
• Quickly bind the corresponding keypad connection to a device (like the Toggle of a light)
• Should mimic a keypad button press including the push and hold to dim a light.
• Contact Connection 1 is linked to Keypad Connection 1, and so on…

Properties

• Device Settings
  • Click Rate: This is where you set the click rate to differentiate from a quick click (single tap) or a longer push and hold

Connections

• • 20 Contacts Inputs: This is where you will bind the driver to devices like the contact on a controller, IO Extender, Z2IO or Z2C (or similar)
  • 20 Keypad Inputs: This is where you will bind the driver to a device like you would a keypad button

FAQ

• Can you give us some examples of how we could use this driver?
  • We have had some requests were an old, centralised lighting system is being changed and need to use existing switchgear. This allows for pulse, press, release inputs to a contact so that the existing switchgear acts as if it were a keypad button
• Can you have more than one Driver per project?
  • Sure can.
• Can you bind multiple connections to a contact connection?
  • Nope.
• Can you bind multiple connections to a keypad connection?
  • Nope.
• What if I have 2 buttons that need to control one light
  • You can bind the one contact to a connection and then connect to other to another contact connection. The corresponding keypad connections can both be bound to the toggle connection of the light.
• I want to try before I buy…
  • No problem, the driver comes with a free 15-day trial

4Drivers has driver to make a seamless integration with tese Biometric readers

You can:
Import all users
Choose actions for each one
Open relay if connected to solution

Try this easy integration and robust solution on you project

Homemation – Crestron Lighting Driver

This is a two-way driver between Control4 and Crestron. This is to be used in combination with the Creston Module written.

Secondary Drivers: 

• To add dimmable lighting loads to the system, use the "HM Dimmable Light" driver.

• To add switched lighting loads to the system, use the "HM Non Dimmable Light" driver.

• To use a relay with non-lighting loads, use the “HM Relay Interface” Driver which allows you to connect a Control4 Relay Driver so that it reflects in the correct place on a Navigator.

• To use a keypad button from Crestron within Control4 you can use the “HM Keypad” Driver. Each button requires an address from Crestron. You can then bind these in connections or use them in programming.

Project validation, error testing, dealer contact and controller monitoring tools for Control4.

This driver is a simple convertor that allows you to use a Dimmer Proxy (Dimmer Driver) within Composer and get 10 Relay Connections out.

Features

• Quickly select the lighting driver from System Design
• Quickly bind the Relay outputs to the Relay Driver you need to control
• If the light is dimmed on via the light icon on a navigator this will reflect on the relay driver
• If the relay device is triggered the commands are routed to the lighting device

This serial RS232 driver supports the Display Technologies Side Masking Projection Screens. It allows you to easily set the aspect ratio to the following configuration through a device specific command:

• 4:3
• 16:9
• 2.00:1
• 2.35:1
• 2.37:1

The latest version of this driver now also supports up to 20 presets.