Overview
Matter is an open smart home standard that lets devices from different brands work together on your local network. This driver is a native Matter controller for Control4. It commissions Matter devices and controls them directly on the local network, with no third-party hub.
Features
- Local Control: Control Matter devices directly on the local network.
- Commissioning: Add a device with a setup code or QR code from the Control4 app or from Composer.
- Auto Setup: Add and bind the correct subdriver for each commissioned device.
- Multi-Admin: Join a device that is already set up in Apple, Google, or another vendor app. The original app keeps working.
Included drivers
- Matter Controller: Acts as the gateway, commissions devices, and creates a connection for each one.
- Matter Light: Lights, in-wall switches and dimmers, and plugs.
- Matter Sensor: Contact, motion, temperature, humidity, and light level.
- Matter Blind: Shades, curtains, and other coverings that raise and lower or open and close.
- Matter Blind (Tilt): Coverings that raise and lower and also tilt. It adds separate Blind and Tilt devices.
- Matter Thermostat: HVAC modes, heat and cool setpoints, fan modes, and humidity when the device reports them.
Limitations
- No BLE Commissioning: This driver does not commission over BLE. Devices set up in a vendor app can still be joined through multi-admin once they are on Wi-Fi or Ethernet.
- No Thread: Only Wi-Fi and Ethernet Matter devices can be commissioned or controlled.
Requirements
- Control4 OS 4.0.0 or higher
- IPv6 enabled on the local network
- Matter devices reachable over Wi-Fi or Ethernet on the same local network
Matter is a registered trademark of the Connectivity Standards Alliance. This driver is not certified by the Alliance. Matter and related marks are trademarks of the Alliance; all rights reserved.
-
Matter Controller DocumentationDownload PDF, 237 KB
-
Matter Light DocumentationDownload PDF, 161 KB
-
Matter Sensor DocumentationDownload PDF, 194 KB
-
Matter Thermostat DocumentationDownload PDF, 152 KB
-
Matter Blind DocumentationDownload PDF, 150 KB
-
Matter Blind (Tilt) DocumentationDownload PDF, 156 KB
v20261115 - 2026-11-15
Added
- Added support for the longer 21 digit setup code printed on some devices.
Fixed
- Fixed an issue where commissioning could stop working after a failed attempt on a controller with no devices yet.
- Fixed an issue where retrying commissioning right after a failed attempt (for example, a mistyped setup code) could time out until the device was reset.
- Fixed commissioning when more than one device in pairing mode matched the setup code.
- Improved the messages shown when commissioning fails, so they now say whether no device was found, the device stopped responding, or the setup code was rejected.
v20261113 - 2026-11-13
Added
- Added support for shades and blinds, including tilt.
v20260926 - 2026-09-26
Fixed
- Fixed an issue that could interrupt commissioning of some Matter devices.
Changed
- Improved discovery for Matter lights and switches, including Leviton.
v20260902 - 2026-09-02
Added
- Added support for thermostats.
v20260826 - 2026-08-26
Added
- Added support for in-wall switches and dimmers.
v20260806 - 2026-08-06
Added
- Initial release.