4Drivers EBECO Thermostat connects EBECO Connect electric floor and room heating thermostats straight to Control4 through the cloud — no PC, gateway, or local service required anywhere on the customer’s network. The driver talks directly to the EBECO Open API from the Control4 controller itself, using the same account credentials as the official EBECO Connect app.
Once configured, it automatically discovers every thermostat registered on the account and puts full control in a built-in, responsive HTML interface available on any Control4 Navigator: turn each unit on or off, adjust the setpoint, and monitor both the room and floor sensor readings at a glance — EBECO thermostats report both at the same time. Scheduling lives right in the interface too, letting you target a single thermostat or every thermostat at once by day of week and time, without touching Control4 Programming.
For projects that want a native look and feel, an optional companion driver exposes each EBECO thermostat as a standard Control4 thermostat card, complete with Presets, so it behaves just like any other HVAC device in the system.
-
Direct cloud integration with EBECO Connect — no local PC, gateway, or bridge hardware
-
Automatic discovery of every registered thermostat on the account
-
Full control: power (on/off) and heating setpoint
-
Simultaneous room and floor temperature readings, shown side by side
-
Built-in HTML interface for any Navigator, in Portuguese, English, or Spanish
-
Multi-device scheduling, by day of week and time, targeting one thermostat or all of them
-
On-screen confirmation while a command is being applied, so the interface never shows a stale state
-
Optional companion driver for a native Control4 thermostat card, with Presets
-
Compatible with Control4 OS 3.0.0 and above
